to home page
 
PCC Software

Software for creation of pipe classes and mechanical calculation of piping components. Read more ...
 
VES Software

Software for the design and mechanical calculation of pressure vessels and heat exchangers. Read more ...
Home Design Standards BN-DS-T11 Saddles for heat exchangers and vessels
BN-DS-T11 Saddles for heat exchangers and vessels Print E-mail

Design standard of Saddles for heat exchangers and vessels. Use this standard for study purposes only.

General Notes:

  1. For material see exchanger drawing
  2. Bolthole diameter to be bolt diameter +6 mm
  3. For saddle locations see exchanger drawing
  4. Mentioned weights are for two bottom saddles
  5. All joint shall be 6 mm continuous fillet welded both sides

The next figure shows a typical design:





  		 
Badger04_jpg.jpg
'reliability is yet to become the most important characterstic of modern companies'
home | privacy | legal
© 2001 - 2011 Red-Bag